Tumble Dry

• 1). Open the LEN200PW1 door. Pull out the lint screen, remove any lint on it and replace it. Load the clothing into the drum with enough room to allow the clothes to tumble loosely during the drying cycle. Insert a dryer sheet if desired. Close the dryer door.
  
  
• 2). Select your drying cycle based on the type of clothing you are drying and adjust the controls as needed. Use low heat settings for delicate clothing. Use the higher heat settings for heavy duty fabrics, such as jeans or towels. Press the Start button to begin the drying cycle.
  
  
• 3). Return to the LEN2000PW1 dryer when you hear the buzzer that signals the end of a cycle. Remove the clothing from the drum after it stops spinning. Check the dryer drum for any debris from the clothing, such as coins or buttons. Close the dryer door.
  
  

Drying Rack

• 1). Open the dryer door. Remove the lint screen if the drying rack has front legs. Place the drying rack inside the LEN2000PW1 the dryer's drum. Slide the rear pegs into the holes on the back wall of the dryer. Place the front legs in the dryer opening if applicable.
  
  
• 2). Place the wet clothing on top of the rack and leave spacing between each piece of clothing. Close the dryer door. Select the desired drying time and temperature on the control panel. Select the no heat cycle if the items you're drying have foam, rubber or plastic in them. Press the Start button.
  
  
• 3). Return to the LEN2000PW1 dryer when you hear the buzzer that signals the end of a cycle. Remove the clothing from the rack after the drum stops spinning. Pull the drying rack out of the holes in the back of the dryer holding it in place. Store the drying rack in a safe place. Close the dryer door.