Instructions to Make 4 Row Beaded Bracelets
- 1). Cut four lengths of wire about 6 inches longer than you want your finished bracelet. An average adult bracelet should measure between 7 and 8 inches.
- 2). Add a crimp bead to your first piece of wire. Pass the wire through the first hole on one half of the clasp, and bring the wire end back through the crimp bead to form a loop. Tighten the loop and crimp in place. Repeat for each wire length.
- 3). Lay out your beads in four rows as you want them to look on the finished bracelet. The length of each row should measure 1/2 inch shorter than your finished piece. Place the spacer bars a third of the way and two thirds of the way down the length of beads.
- 4). String all the beads up to the first spacer bar onto their respective wires. String the spacer bar onto all four wires to help maintain the shape of the bracelet. Repeat with the next set of beads, the next spacer bar and the final set of beads.
- 5). Add a crimp bead to each wire. Attach each wire to its corresponding loop on the other side of clasp by passing the wire end through the loop and back through the crimp bead. Pull tight and crimp in place.
- 6). Run all the wire tails back through the beads on each strand to hide them.